Operation CHARM: Car repair manuals for everyone.

B1015

Diagnostic Chart:




CIRCUIT DESCRIPTION
Modules connected to the class 2 serial data circuit monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules.

CONDITIONS FOR RUNNING THE DTC
^ Voltage supplied to the module is in the normal operating voltage range (approximately 9 to 16 volts).
^ Diagnostic trouble codes U1300 and U1301 do not have a current status.
^ The vehicle power mode (ignition switch position) requires serial data communication to occur.

CONDITIONS FOR SETTING THE DTC
The VIN information stored in the BCM and in the PCM do not match.

ACTION TAKEN WHEN THE DTC SETS
The SERVICE VEHICLE SOON telltale illuminates.

CONDITIONS FOR CLEARING THE DTC
^ A current DTC B1015 will clear if the malfunction is no longer present and a scan tool is used to clear the DTC.
^ A history DTC B1015 will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present or if a scan tool is used to clear the DTC.

TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table.
2. This step checks to see if the correct VIN information is in the BCM.
3. This step checks to see if the correct VIN information is in the PCM.