P0724
Diagnostic Chart:
Schematic:
CIRCUIT DESCRIPTION
The TCC brake switch indicates brake pedal status to the PCM. The TCC brake switch indicates that the brake pedal is either applied or released. The normally-closed switch supplies battery voltage to the PCM. Applying the brake pedal opens the TCC brake switch, interrupting voltage to the PCM. When the PCM receives 0 volts at the TCC brake switch input, the PCM turns OFF the Torque Converter Clutch Pulse Width Modulation (TCC PWM) solenoid valve.
If the PCM detects a closed TCC brake switch (indicating pedal released) during a number of decelerations, then DTC P0724 sets. DTC P0724 is a type C DTC.
CONDITIONS FOR RUNNING THE DTC
No VSS DTC P0502 or P0503.
CONDITIONS FOR SETTING THE DTC
The TCC brake switch indicates continuously CLOSED (12 volts) while the following conditions occur 8 times consecutively:
^ The vehicle speed is greater than 32 km/h (20 mph) for 6 seconds;
^ Then the vehicle speed decreases to 8 km/h (5 mph) and takes 3 seconds;
^ Finally, the vehicle speed is less than 8 km/h (5 mph).
ACTION TAKEN WHEN THE DTC SETS
The PCM does not illuminate the Malfunction Indicator Lamp (MIL).
^ The PCM records the operating conditions when the Conditions for Setting the DTC are met. The PCM stores this information as Failure Records.
^ The PCM stores DTC P0724 in PCM history.
CONDITIONS FOR CLEARING THE DTC
^ A scan tool can clear the DTC.
^ The PCM clears the DTC from PCM history if the vehicle completes 40 consecutive warm-up cycles without a non-emission-related diagnostic fault occurring.
^ The PCM cancels the DTC default actions when the fault no longer exists and the ignition switch is OFF long enough in order to power down the PCM.
DIAGNOSTIC AIDS
^ Inspect the connectors at the controller, the component and all other circuit connecting points for an intermittent condition. Refer to Testing for Intermittent and Poor Connections in Diagrams.
^ Inspect the circuit wiring for an intermittent condition. Refer to Testing for Electrical Intermittents in Diagrams.
TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table.
2. A Scan Tool display that changes from Closed to Open when the TCC brake switch is disconnected indicates a faulty switch.