Structural Brace: Service and Repair

Cross Vehicle Brace Replacement

Removal Procedure




1. Open the hood.
2. Remove the nuts from the cross vehicle brace.
3. Remove the cross vehicle brace from the vehicle.

Important: The stud plates will fall out and possibly get caught under the vehicle, a helper should hold the stud plates during the removal.





4. Remove the stud plates push on nuts.
5. Remove the stud plates from the vehicle.

Installation Procedure

Important: The stud plates will require a helper to hold the stud plates during the installation of the push on nuts.





1. Install the stud plates to the vehicle.
2. Install the stud plates push on nuts to the studs.




3. Install the cross vehicle brace onto the stud plates.

Notice: Refer to Fastener Notice in Cautions and Notices.




4. Install the nuts to retain the cross vehicle brace to the vehicle.

Tighten the nuts to 18 Nm (13 lb ft).

5. Close the hood.