Control Assembly Replacement (CJ2)

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the instrument panel accessory trim plate.
3. Remove the front floor console it equipped.
4. Remove the HVAC control assembly mounting bolts.




5. Disconnect the electrical connector.
6. Remove the HVAC control assembly.

INSTALLATION PROCEDURE




1. Connect the electrical connector.




2. Install the HVAC control assembly.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the HVAC control assembly mounting bolts.

Tighten
Tighten the control assembly bolts to 2 N.m (18 lb in).

4. Install the instrument panel accessory trim plate.
5. Install the front floor console if equipped.
6. Connect the negative battery cable.


For a description of the RPO Code(s) shown in this article/image, refer to the RPO Code List found at Vehicle/Application ID