HVAC System - Manual

CONTROL ASSEMBLY REPLACEMENT (CJ3)

REMOVAL PROCEDURE




1. Remove the I/P accessory trim plate.
2. Remove the front floor console if equipped.
3. Remove the retaining bolts from the HVAC control assembly.
4. Pull the control assembly out from the instrument panel.




5. Disconnect the electrical connectors and the vacuum harness if equipped from the HVAC control assembly.
6. Remove the HVAC control assembly.

INSTALLATION PROCEDURE




1. Connect the electrical connectors and the vacuum harness if equipped to the HVAC control assembly.




2. Install the HVAC control assembly into the instrument panel.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the retaining bolts to secure the HVAC control assembly.

Tighten
Tighten the control assembly bolts to 2 N.m (18 lb in).

4. Install the I/P accessory trim plate.
5. Install the front floor console if equipped.

For a description of the RPO Code(s) shown in this article/image, refer to the RPO Code List found at Vehicle/Application ID