Accelerator Pedal: Service and Repair

REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Remove the left instrument panel sound insulator.
3. Disconnect the accelerator cable (5) from accelerator pedal (1).
4. Remove the bolts (2) and studs (3) holding the accelerator pedal to the bulk head (4).
5. Remove the accelerator pedal.

INSTALLATION PROCEDURE
1. Install the accelerator pedal (1) to bulkhead (4).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the accelerator pedal bolt (3) and stud (2).

Tighten
Tighten the accelerator pedal assembly bolts and studs to 3.0 N.m (27 lb in).

3. Connect the accelerator cable (5) to accelerator pedal (1).
4. Inspect the accelerator pedal for the following conditions:
^ Inspect for complete throttle opening and closing positions by operating the accelerator pedal (The throttle should operate freely without binding between full closed and wide open throttle).
^ Inspect for poor carpet fit under the accelerator pedal.
5. ReInstall the left instrument panel sound insulator.