Fuel Level Sensor: Service and Repair

REMOVAL PROCEDURE

IMPORTANT: Always maintain cleanliness when servicing fuel system components.

1. Relieve fuel system pressure. Refer to Fuel Pressure Relief Procedure.
2. Remove the modular fuel sender assembly.
3. Remove the fuel level sensor (5) from the modular fuel sender.

INSTALLATION PROCEDURE
1. Reinstall the fuel level sensor (5) to modular fuel sender.
2. Reinstall the fuel sender assembly.
3. Tighten the fuel filler cap.
4. Connect the negative battery cable.
5. Inspect the fuel system for leaks by performing the following steps:
5.1. Turn the ignition switch ON for 2 seconds
5.2. Turn the ignition switch OFF for 10 seconds.
5.3. Turn the ignition switch ON.
5.4. Inspect for fuel leaks.