Generator Brace Replacement
REMOVAL PROCEDURE1. Loosen the generator pivot bolt (1).
2. Remove the generator rear brace nut (4).
3. Remove the generator rear brace.
INSTALLATION PROCEDURE
1. Install the generator rear brace.
2. Install the generator pivot bolt (1) finger tight.
3. Install the generator rear brace nut (4) finger tight.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Tighten the generator bolt and nut as described:
4.1. Tighten
Tighten the generator pivot bolt (1) to 50 N.m (37 lb ft).
4.2. Tighten
Tighten the generator rear brace nut (4) to 25 N.m (18 lb ft).