B0041

Diagnostic Chart (Part 1 Of 2):

Diagnostic Chart (Part 2 Of 2):

Wiring Diagram:

CIRCUIT DESCRIPTION
The LF/driver inflatable restraint side impact inflator module deployment loop is a 2 wire circuit. When you first turn ON the ignition, the inflatable restraint Sensing and Diagnostic Module (SDM) performs tests to diagnose critical malfunctions within itself. Then the SDM performs the following continuous diagnostic tests on the deployment loops:
^ Deployment loop voltage out of range test
^ Deployment loop resistance measurement test

If the voltage out of range test detects a short to voltage condition the resistance measurement test for that deployment loop will not be performed.

CONDITIONS FOR RUNNING THE DTC
Deployment loop voltage out of range test:
^ Ignition 1 voltage is within the normal operating voltage range.
^ LF side deployment loop is not shorted to voltage.
^ LF side high terminal is less than 2.4 volts.

Deployment loop resistance measurement test:
^ Ignition 1 voltage is within the normal operating voltage range.
^ LF side deployment loop is not shorted to voltage.
^ LF side deployment loop is not shorted to ground.

CONDITIONS FOR SETTING THE DTC
Deployment loop voltage out of range test - LF side high is less than 2.4 volts, LF side loop resistance is greater or equal to 6 ohms for 500 milliseconds.

Deployment loop resistance measurement test LF side deployment loop resistance is more than 4.8 ohms for 500 milliseconds.

ACTION TAKEN WHEN THE DTC SETS
The SDM commands ON the AIR BAG warning lamp via Class 2 serial data.

CONDITIONS FOR CLEARING THE DTC
^ The LF side deployment loop resistance is 4.8 ohms or less for 500 milliseconds.
^ The LF side high terminal is greater than 2.4 volts and LF side deployment loop resistance is less than 6 ohms for 500 milliseconds.
^ You can issue a CLEAR CODES command
^ A history DTC will clear once 255 malfunction free ignition cycles have occurred

DIAGNOSTIC AIDS
The following can cause an intermittent condition:
^ The inflatable restraint side impact inflator module 2-way harness connector.
^ The SDM wiring harness connector.
^ The wire to terminal connections in the LF side high circuit.
^ The wire to terminal connections in the LF side low circuit.
^ Refer to Intermittents and Poor Connections in Diagrams.

TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table.
2. This step checks the LF/driver side air bag in-line connector.
5. This step checks to see if there is a malfunctioning LF side air bag (inflatable restraint side impact inflator module).
7. This step checks to see if the inflatable restraint sensing and diagnostic module (SDM) wiring harness connector is OK.
9. This step checks to see if there is an open or a high resistance in the LF side high deployment circuit.
11. This step determines if there is an open or high resistance in the LF side low deployment circuit or if there is a malfunctioning SDM.