P1546

Diagnostic Chart:

Schematic:

CIRCUIT DESCRIPTION
Output driver modules (ODMs) are used by the PCM to turn on many of the current-driven devices that control various engine and transaxle functions. Each ODM is capable of controlling up to 7 separate outputs by applying ground to whichever device the PCM is commanding ON. Unlike the quad driver modules (QDMs) used in prior model years, ODMs have the capability of diagnosing each output circuit individually. If DTC P1546 is set, an incorrect voltage level has been detected on the output circuit that controls the A/C compressor control relay.

CONDITIONS FOR RUNNING THE DTC
The ignition is ON.

CONDITIONS FOR SETTING THE DTC
^ An improper voltage level has been detected on ODM A output 1. This is the A/C compressor control relay control circuit.
^ The above conditions are present for at least 30 seconds.

ACTION TAKEN WHEN THE DTC SETS
^ The PCM will not illuminate the malfunction indicator lamp (MIL).
^ The PCM will store conditions which were present when the DTC set as Failure Records data only. This information will not be stored as Freeze Frame data.

CONDITIONS FOR CLEARING THE MIL/DTC
^ A history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using the scan tool Clear Info function.

DIAGNOSTIC AIDS
Check for the following conditions:
^ A faulty connection at the PCM - Inspect harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal to wire connection. Use a corresponding mating terminal to test for proper terminal tension.
^ A damaged harness - Inspect the wiring harness for damage. If the harness appears to be OK, disconnect the PCM, turn the ignition ON and observe a DMM connected between the A/C compressor control relay control circuit and ground at the PCM harness connector while moving connectors and wiring harnesses related to the A/C compressor control relay. A change in voltage will indicate the location of the malfunction.

Review the Fail Records vehicle mileage since the diagnostic test last failed. This may help determine how often the condition occurs that caused the DTC to set.

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table.
1. The powertrain OBD System Check prompts you to complete some basic checks and store the freeze frame and failure records data on the scan tool.
2. Listen for an audible click when the relay operates. Command both the ON and OFF states. Repeat the commands as necessary.
3. Tests for voltage at the coil feed side of the relay.
4. Verifies that the PCM is providing ground to the relay.
5. Tests if ground is constantly being applied to the relay.
12. The PCM utilizes Electrically Erasable Programmable Read Only Memory (EEPROM). When the PCM is replaced, the new PCM must be programmed.