10 Minute Re-Learn Procedure

Use this procedure after replacing any of the following components:
^ The keys/lock cylinders
^ The theft deterrent controller module
^ The PCM (if necessary, refer to the Important statement above)

Tools Required
^ Scan Tool
^ Techline Terminal with current Service Programing System (SPS) software

1. Connect the Tech 2 Diagnostic tool.
2. Select Request Information under Service Programing.
3. Disconnect the Tech 2 from the vehicle and connect the Tech 2 to a Techline Terminal.
4. On the Techline Terminal, select Theft Module Re-Learn under Service Programming.
5. Disconnect the Tech 2 from the Techline Terminal and re-connect the Tech 2 to the vehicle.
6. Turn ON the ignition, with the engine OFF, using a master Pass Key III key (black).
7. Select VTD Re-Learn under Service Programming.
8. At this point the Tech 2 must remain connected for the duration of the 10 minute Re-Learn period.
9. Observe the security telltale, after approximately 10 minutes the telltale will turn off (the vehicle is now ready to re-learn the key information and/or passwords on the next ignition switch transition from OFF to CRANK).
10. Turn OFF the ignition and wait 5 seconds.
11. Start the vehicle (the scan tool has now learned the key and password information).
12. Clear any DTCs using the scan tool.