Relay/Fuse Center Replacement (Rear Fuse Block)

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable from the battery.
2. Remove the rear fuse block cover.
3. Remove the positive battery cable nut (1) and cable from the rear fuse block.
4. Unclip the four retaining clips, lift up the electrical fuse block and turn the block over.
5. Remove the three connector screws, and remove all of the connectors from the fuse block.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.

1. Install all of the connectors to the rear fuse block and hand start the bolts.

Tighten
Tighten the bolts to 6.6 N.m (58 lb in).

2. Install the rear fuse block into the base assembly ensuring all the clips engage.
3. Install the positive battery cable and nut (1) to the rear fuse block.

Tighten
Tighten the bolts to 15 N.m (11 lb ft).

4. Connect the negative battery cable from the battery.