B2113

Diagnostic Chart:

Schematic:

CIRCUIT DESCRIPTION
The Memory Seat Module (MSM) switches are normally open. They switch 12 V to the MSM when they are pressed. The MSM commands the driver seat to move in response to the switch inputs.

CONDITIONS FOR RUNNING THE DTC
The MSM must be powered. The MSM checks the switch inputs and the position sensor signals continuously.

CONDITIONS FOR SETTING THE DTC
^ If a seat direction switch continues to be active for 30 seconds after a motor controlled by that switch reaches the end of its travel, the switch will be considered shorted and the MSM will set the DTC.
^ If a position sensor DTC is current and the associated switch is active for 30 continuous seconds, the switch will be considered shorted and the MSM will set a switch DTC.
^ A switch DTC will not set if DTC B1327 is current.

ACTION TAKEN WHEN THE DTC SETS
^ A motor output driven in response to a switch considered failed, is deactivated for both directions.
^ All memory recall commands are ignored.
^ The MSM will respond to any other switch input that has not set a DTC.

CONDITIONS FOR CLEARING THE DTC
The DTC automatically clears when the switch setting the DTC does not test out of limits or closed. The DTC then changes from a current fault to a history fault.

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table.
2. Checks the existing state of the driver's memory/seat switch by using the current state of the input parameter.
4. Determines if the switch contacts are stuck closed.
5. Determines if there is a short to battery positive voltage in the switch input circuit.
10. Clears all DTCs after the repair is complete and also verifies the repair.