Closeout/Insulator Panel Replacement - Left

Closeout/Insulator Panel Replacement - Left

Removal Procedure

Notice: Install the fasteners in to the same location that they were removed from. Make note of the positions that the fasteners are in before removal, as improper installation of the fasteners may lead to possible accelerator pedal or brake pedal binding.






1. Remove the left sound insulator fasteners (1) from the IP.
2. Disconnect the following components:

* The courtesy lamp
* The DSIR connector
* The heater temperature sensor connector

3. Remove the left sound insulator (2).



Installation Procedure






Important: Inspect the left sound insulator (2) for the proper clearance to the accelerator and brake pedals. Improper clearance may result in binding of the accelerator or brake pedals.


1. Position the left sound insulator (2) to the IP with the forward left tab is located above the parking brake bracket flange.
2. Connect the following components to the insulator:

* The courtesy lamp
* The DSIR connector
* The heater temperature sensor connector


Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the fasteners (1) to the IP.

Tighten the fasteners to 1.9 N.m (17 lb in).