Drive Belt: Service and Repair

Removal Procedure
The supercharged 3300 engine uses two drive belts. The outer belt drives the supercharger. The inner belt drives the generator, power steering pump, coolant pump and air conditioning compressor. All driven accessories are rigidly mounted to the engine. Drive belt tension is maintained by the spring loaded belt tensioners. Each belt has its own tensioner. A belt squeak when the engine is started or stopped is normal and has no effect on belt durability. The drive belt tensioner can control belt tension over a broad range of belt lengths due to stretching; however, there are limits to the tensioners ability to compensate. Using the tensioner outside of its operating range can result in poor tension control and/or damage to the tensioner. The belt should be replaced when this condition occurs.
1. Rotate the tensioner to remove the drive belt.





2. Remove the supercharger belt.





3. Remove the drive belt.

Installation Procedure





1. Install the drive belt.





2. Install the supercharger belt.