HVAC System - Automatic

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Open and lower the instrument panel compartment by carefully releasing the rear holding tabs.
3. Pull down in order to remove the programmer (1).
4. Disconnect the electrical connectors from the programmer.

INSTALLATION PROCEDURE

IMPORTANT: After the programmer is replaced, recalibrate the actuators for proper travel. Turn ON the ignition for 3 minutes to recalibrate the programmer and the actuators for proper travel.




1. Connect the electrical connectors to the programmer.
2. Install the programmer (1) into the retainer on the bracket (2).
3. Close the instrument panel compartment.
4. Connect the negative battery cable.