Fuel Pump Control Unit: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Pull back the rear compartment trim panel (1).
3. Remove the fuel pump control module attaching nut (3).
4. Remove the fuel pump control module electrical connector (2) from the fuel pump control module (1).

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.

1. Install the fuel pump control module (1).
2. Install the fuel pump control module attaching nut (3) to the fuel pump control module (1).

Tighten
Tighten the fuel pump control module attaching nut to 9 N.m (80 lb in).

3. Install the fuel pump control module electrical connector (2) to the fuel pump control module.
4. Install the rear compartment trim panel (1).
5. Connect the negative battery cable.