Rear Electrical Center Replacement

Rear Electrical Center Replacement




REMOVAL PROCEDURE
1. Remove the rear seat cushion.
2. Disconnect the left harness connector.
3. Remove the harness retainer push nut and position harness aside to provide clearance.
4. Remove the electrical center retaining nuts.
5. Rotate the electrical center to provide access to the lower right side harness connectors.
6. Disconnect the remaining harness connectors and remove the electrical center.

INSTALLATION PROCEDURE
1. Position the electrical center and connect the harness connectors.
2. Rotate the electrical center and install to the studs.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the nuts securing the electrical center.

Tighten
Tighten the fasteners to 5 N.m (49 lb in).

4. Install the left side harness connector.
5. Position harness into the retainer and install the push nut.
6. Install the rear seat cushion.