Radio/Stereo: Service and Repair

REMOVAL PROCEDURE
1. Remove the IP cluster trim plate.
2. Remove the fasteners (2) that secure the radio (1).
3. Pull the radio (1) rearward.
4. Disconnect the radio electrical connectors (3).
5. Disconnect the antenna lead (4).

INSTALLATION PROCEDURE
1. Connect the radio electrical connector (3).
2. Connect the antenna lead (4).
3. Install the radio (1)

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the radio fasteners (2).

Tighten
Tighten the fasteners to 1.8 N.m (16 lb in).

5. Install the IP cluster trim plate.