Fuel Tank Pressure Sensor: Service and Repair
REMOVAL PROCEDURETOOLS REQUIRED
J 34730 Fuel Pressure Gauge
1. Remove the fuel tank filler pipe cap.
2. Remove the rear compartment trim panel (1).
3. Remove the bolts from the fuel sender access panel (2).
4. Remove the fuel tank pressure sensor electrical sensor connector.
5. Remove the fuel tank pressure sensor from the sender.
INSTALLATION PROCEDURE
1. Install the new fuel tank vapor pressure sensor into the modular fuel sender.
2. Install the fuel tank pressure sensor electrical sensor connector.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the fuel sender access panel (2) bolts.
Tighten
Tighten the bolts to 2 N.m (18 lb in).
4. Install the rear compartment trim panel.
5. Install the fuel tank filler pipe cap.