Restraint System

CAUTION: To help avoid personal injury from unrepaired crash damage to a restraint system:
^ Replace each seat belt system worn during a crash unless the crash was minor.
^ Perform the seat belt check for each seat belt system. Replace the seat belt system if there is any doubt about the condition Of system components.


Front Seat Belt System
^ The front seat belt system includes a driver and/or passenger seat belt retractor and buckle.
^ The driver's seat belt system, includes a seat belt switch in the driver seat buckle which controls a reminder lamp and a tone alarm. When the driver seat belt is buckled, the driver's door is closed, and the ignition switch is turned ON, the following events will occur:
- The tone alarm will not operate.
- The reminder lamp will not operate.
^ When the driver's seat belt is not buckled, the driver's door is closed, and the ignition switch is in RUN, the following events will occur:
- The tone alarm will operate for 4 to 8 seconds and then go OFF.
- The reminder lamp will operate for 20 seconds, until the driver seat belt is buckled.

Rear Seat Belt System
The rear seat belt system includes the following components:
^ he rear seat belt retractor is located under the rear shelf trim panel and is attached to the rear shelf body panel.
^ The center rear seat belt buckle and the outer seat belt buckle are located in the center of the seat cushion and they are attached to the rear floor pan