Crankshaft Position Sensor: Service and Repair
REMOVAL PROCEDURETOOLS REQUIRED
^ J 36660-A Torque/Angle Meter.
^ J 37096 Flywheel Holding Tool.
^ J 38197 Balancer Remover.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Remove the serpentine belts from the crankshaft pulley.
3. Raise the vehicle on a hoist.
4. Remove the right front wheel and tire assembly.
5. Remove the right inner fender access cover.
6. Hold the flywheel with flywheel holding tool.
7. Using 28 mm socket, remove the crankshaft harmonic balancer retaining bolt.
8. Remove the crankshaft harmonic balancer using special tool balancer remover.
9. Remove the crankshaft position sensor shield (1) (Do Not use a pry bar).
10. Disconnect the sensor electrical connector.
11. Remove 2 attaching bolts from the crankshaft position sensor.
12. Remove the crankshaft position sensor from block face.
INSTALLATION PROCEDURE
1. Position the Crankshaft Position (CKP) sensor to the block.
NOTE: Refer to Fastener Notice in Service Precautions.
2. nstall the bolts that hold the CKP sensor to the block face.
Tighten
Tighten the bolts to 20-40 N.m (14-28 lb ft).
3. Install the crankshaft position sensor shield (1).
4. Connect the CKP sensor electrical connector.
5. Position the crankshaft harmonic balancer on the crankshaft.
6. Hold the flywheel with J 37096 Flywheel Holding Tool.
Tighten
Using J 36660-A, tighten the harmonic balancer bolt to 150 N.m +76 degrees (110 lb ft +76 degrees).
7. Install the right inner fender access cover.
8. Install the right front wheel and tire assembly.
Tighten
Tighten the wheel nuts to 140 N.m (104 lb ft).
9. Lower the vehicle.
10. Install the serpentine belts.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
11. Connect the negative battery cable.
12. Perform the Crankshaft Variation Learn Procedure. Programming and Relearning