Body Control Module (BCM) - Programming/RPO Configuration

BODY CONTROL MODULE (BCM)
After replacement of the body control module, use a scan tool to perform the following procedure.
1. Setup SDM Serial Number in BCM Procedure (This procedure sets up the BCM).
2. Set the Point of Sale in the BCM module to the correct country.
3. Configure the Load Management Option.

PROCEDURE TO SET UP BCM MODULE
1. Connect a scan tool to the data link connector (DLC).
2. Turn ON the ignition, with the engine OFF.
3. Under the BCM Main Menu, select Special Functions. Under the Special Functions menu, one of the choices is Setup SDM Serial Number in BCM.
4. The user selects one of the following:
^ Setup SDM Serial Number in BCM, (to continue with the procedure).
^ Exit, to go back to Special Functions menu.
5. After the user chooses Setup BCM, the scan tool displays a screen as follows:
^ Do you want to set up a Body Control Module?
^ Select Setup BCM to set up module or press Exit to go back to Special Functions menu.
^ If the user selects Setup BCM, the scan tool displays: Now Setting Up the New Body Control Module.
^ Once complete, the scan tool displays: Body Control Module Setup is Complete.
^ Press EXIT to Go to Special Functions Menu.
6. To complete the procedure, select Set Options from the Special Functions Menu.
7. Under the Set Options menu, The user selects one of the following:
^ Point of Sale, (to continue with the procedure) follow the scan tool on screen instructions to Select the Point of Sale.
^ Load Management Option, (to continue with the procedure) follow the scan tool on screen instructions to Select the Load Management Option.
^ Press Exit, to go back to Special Functions menu.