Remote Keyless Entry (RKE) - Transmitter

IMPORTANT: All transmitters which are to be recognized by the RFA Module must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to four transmitters can be programmed. The order that the transmitters are programmed is important, the first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. The number on the transmitters are for reference only, #2 can be programmed as #1 or vice versa. Additional transmitters are available that do not have a number on them. Use care to program the transmitters correctly.

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. Use the scan tool RFA Module Special Function:
Program Key Fobs in order to place the Remote Control Door Lock receiver into Program Mode. The doors will Lock and then unlock to confirm program mode.

IMPORTANT: The scan tool must stay connected until all transmitters are programmed.

4. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
5. Repeat the previous step to program up to four transmitters.
6. Remove the scan tool.