Manifold Absolute Pressure (MAP) Sensor Diagnosis

Diagnostic Chart (Part 1 Of 2):

Diagnostic Chart (Part 2 Of 2):

Schematic:

CIRCUIT DESCRIPTION
The Manifold Absolute Pressure (MAP) sensor responds to changes in intake manifold pressure. The MAP sensor signal voltage to the Powertrain Control Module (PCM) varies from below 2 volts at idle to above 4 volts with the key ON, engine not running or at Wide Open Throttle. The MAP sensor is used to determine manifold pressure changes while the EGR flow test diagnostic is being run, refer to DTC P0401 Exhaust Gas Recirculation (EGR) Flow Insufficient. Also to update the Barometric Pressure Reading (BARO), and as a enabling factor for other diagnostics. The PCM monitors the MAP signals for voltages outside the normal range of the MAP sensor. If the PCM detects a MAP signal voltage that is excessively high, refer to DTC P0108 Manifold Absolute Pressure (MAP) Sensor Circuit High Voltage. If the PCM detects a MAP signal voltage that is excessively low, refer to DTC P0107 Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage. P0401 P0108 P0107

DIAGNOSTIC AIDS
Inspect for the following conditions:
^ Monitor the MAP sensor using a scan tool. If the MAP sensor does not respond to throttle changes, test the 3X Reference circuits from the ignition control module to the PCM.
^ If the 3X reference signal is lost the PCM will only update the MAP sensor reading once per key cycle, when the engine is first started. Depending on where the MAP sensor voltage is when the engine is started, the high or low voltage MAP sensor DTCs will set.
^ Inspect the connection at the PCM - Inspect the harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal to wire connection. Refer to Testing for Intermittent and Poor Connections and Connector Repairs in Diagrams.
^ Damaged harness - Inspect the wiring harness for damage. If the harness appears to be OK, observe the MAP display on a scan tool while moving the connectors and wiring harnesses related to the sensor. A change in the display will indicate the location of the fault. Refer to Wiring Repairs in Diagrams.
^ Inspect for kinked and damaged vacuum hoses, ensure that a good vacuum source is available. Refer to Emission Hose Routing Diagram.