Quick-Connect Fittings

CAUTION: In order to Reduce the Risk of Fire and Personal Injury:
^ If nylon fuel pipes are nicked, scratched or damaged during Installation, Do Not attempt to repair the sections of the nylon fuel pipes. Replace them.
^ When Installing new fuel pipes, Do Not hammer directly on the fuel harness body clips as it may damage the nylon pipes resulting In a possible fuel leak.
^ Always cover nylon vapor pipes with a wet towel before using a torch near them. Also, never expose the vehicle to temperatures higher than 115°C (239°F) for more than one hour, or more than 90°C (194°F) for any extended period.
^ Before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends. This will ensure proper reconnection and prevent a possible fuel leak. (During normal operation, the O-rings located In the female connector will swell and may prevent proper reconnection if not lubricated.)

Quick-connect type fittings provide a simplified means of disconnecting and connecting fuel system components. Depending on the vehicle type, there are two types of quick-connect fittings. Each are used at different locations In the fuel system. Each type of quick-connect fitting consists of a unique female connector and a compatible male fuel pipe end. An O-ring is located Inside the female connector, witch provides the fuel seal. Integral locking tabs or fingers hold the quick-connect fittings together.