Ignition Coil: Service and Repair
REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Disconnect the spark plug wires. Noting the position that they were removed.
3. Remove 2 screws (1) securing the coil (2) to the ignition control module (3).
4. Remove the coil (1).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Attach the coil assembly (2) to the ignition control module (3).
2. Install two attaching screws (1).
Tighten
Tighten the screws to 4-5 N.m (40 lb in).
3. Connect the spark plug wires.