Rear Folding Seat Back Cover Replacement

Rear Folding Seat Back Cover Replacement

Removal Procedure

1. Remove the rear seat back. Refer to Rear Seat Back Cushion Replacement (Non Folding) (Rear Seat Back Cushion Replacement (Non Folding))Rear Seat Back Cushion Replacement (Folding) (Rear Seat Back Cushion Replacement (Folding)).
2. Remove the rear seat back bolsters. Refer to Rear Split Folding Seat Back Bolster Replacement (Rear Split Folding Seat Back Bolster Replacement).




3. Remove the bolts from the rear split folding seat back frame.




4. Remove the left rear seat back from the rear seat back frame.




5. Remove the right rear seat back from the rear seat back frame.




6. Unhook the J-hook retainers at the bottom of the right and/or left rear seat back.
7. Pull back the right and/or left carpet in order to expose the rear seat trim flaps in order to remove the staples.




8. Reach inside of the right and/or left rear seat back cover in order to unfasten the hook and loop retainers securing the rear seat back cover to the pad.
9. Remove the rear seat folding armrest, if equipped. Refer to Rear Seat Armrest Replacement (Rear Seat Armrest Replacement).




10. Remove the right and/or left rear seat back cover from the rear seat back, by pulling the rear seat back cover up and over the pad.

Installation Procedure




1. Install the right and/or left rear seat back cover to the rear seat back, by pulling the rear seat back cover down and over the pad.
2. Reach inside of the right rear seat back cover and reposition the rear seat back release pullstrap through the rear seat back cover.
3. Align the hook and the loop retainers.




4. Use firm hand pressure in order to fasten the hook and the loop retainers, securing the rear seat back cover to the pad.
5. Install the rear seat folding armrest, if equipped. Refer to Rear Seat Armrest Replacement (Rear Seat Armrest Replacement).




6. Reposition the rear seat back cable on the right rear seat back.
7. Reposition the rear seat trim flaps.
8. Install new staples to the rear seat trim flaps.




9. Fasten the J-hook retainer at the bottom of the right and/or left rear seat back.




10. Install the left rear seat back to the rear seat back frame.




11. Install the right rear seat back to the rear seat back frame.





Notice: Refer to Fastener Notice in Cautions and Notices.

12. Install the bolts to the rear split folding seat back frame.

Tighten the bolts to 10 Nm (89 lb in).

13. Install the rear seat back bolsters. Refer to Rear Split Folding Seat Back Bolster Replacement (Rear Split Folding Seat Back Bolster Replacement).
14. Install the seat back. Refer to Rear Seat Back Cushion Replacement (Non Folding) (Rear Seat Back Cushion Replacement (Non Folding))Rear Seat Back Cushion Replacement (Folding) (Rear Seat Back Cushion Replacement (Folding)).