Rear Side Door Stationary Window Replacement

Rear Side Door Stationary Window Replacement

Removal Procedure

1. Position the window in the full down position.
2. Remove the trim panel. Refer to Rear Side Door Trim Panel Replacement Service and Repair
3. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement (Service and Repair).
4. Remove the inner sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement (Rear Side Door Window Inner Sealing Strip Replacement).
5. Remove the outer belt sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement (Rear Side Door Window Outer Sealing Strip Replacement).
6. Lower the rear door window as low as possible in the door opening and remove the two screws attaching it to the regulator.
7. Slide the window glass down to the bottom of the door while keeping it in the front weatherstrip channel.
8. Partially remove the rear door window weatherstrip from the channel between the door glass and the stationary window and part way across the top of the window.




9. Remove the door stationary window screws.
10. Remove the door stationary window bolt.




11. Remove the rear door stationary window channel bolt.
12. Rotate the window foreword and remove it from the rear door.

Installation Procedure




1. Position the rear door stationary window in the rear door.
Verify that the rear door window is in the channel of the stationary window and also the front channel.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Loosely install the rear door stationary window channel bolt.
Loosely install the two rear door stationary window screws.

Tighten the rear door stationary window bolt to 10 Nm (89 lb in).




3. Now tighten the door stationary window screws.

Tighten the door stationary window screws to 2 Nm (18 lb in).

4. Install the rear door window weatherstrip.
5. Slide the rear door glass up from the bottom of the door, keeping it in the channels and attach it to the regulator.
6. Check the glass movement by using the regulator motor.
7. Install the rear door outer belt sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement (Rear Side Door Window Outer Sealing Strip Replacement).
8. Install the rear door inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement (Rear Side Door Window Inner Sealing Strip Replacement).
9. Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement (Service and Repair).
10. Install the rear door inner trim panel. Refer to Rear Side Door Trim Panel Replacement Service and Repair
11. Raise the rear door window to the full up position.