Engine Support Fixture

Engine Support Fixture

^ Tools Required
- J28467-B Universal Engine Support Fixture
- J 42478 Engine Support Fixture Adapters

Installation Procedure





1. Remove the two rearward strut bolts from the right and left struts towers.
2. Install the J 42478 (2) into the strut threads.
3. Place the strut adapters (J 28467-33A) (1) on top of the four remaining forward strut tower bolts.





4. Install the strut tower support assemblies (J 28467-5A) over the adapters J 42478 and (J 28467-33A).





5. Install the T-Bolts to the J 42478 and (J 28467-33A).





6. Install the strut tower tube (J 28467-3) into the strut tower support assemblies (J 28467-5A).





7. Install the 1/2 inch x 2.5 inch quick release pin (J 28467-10) (2) through the strut tower support assembly (J 28467-5A) (3) and the strut tower tube (J 28467-3) (1) on one side only.





8. Install the radiator shelf tube (J 28467-2A) on top of the strut tower tube (J 28467-3) over the rear engine lift bracket.





9. Install the round tube of the front support assembly (J 28467-4A) through the large hole in the radiator shelf tube (J 28467-2A). The hole used in the radiator shelf tube (J 28467-2A) depends on the vehicle application.
10. Place the rubber padded foot of the front support assembly (J 28467-4A) on the upper tie bar.
11. Install the 7/16 inch x 2.0 inch quick release pin (J 28467-9) through the hole in the front support assembly (J 28467-4A) in order to level the radiator shelf tube (J 28467-2A).





12. Install the cross bracket assembly (J 28467-1A).
13. Hand tighten the cross bracket assembly (J 28467-1A) wing nuts.





14. Install the lift hook (J 28467-7A) through the lift hook bracket (J 28467-6A).
15. Install the 1/2 inch lift hook washer. and lift hook wing nut (J 28467-34) onto the lift hook (J 28467-7A).




16. Install the assembled lift hook bracket (J 28467-6A) (1) over the strut tower tube (J 28467-3) (2).
17. Adjust the assembled lift hook bracket (J 28467-6A) (1) in order to align the hook with the front engine lift hook bracket.





18. Install the lift hook (J 28467-7A) through the front engine lift hook bracket. Ensure the hook does not damage the surrounding components.





19. Repeat steps 14 and 15.
20. Install the assembled lift hook bracket (J 28467-6A) (1) over the radiator shelf tube (J 28467-2A) (2).
21. Adjust the assembled lift hook bracket (J 28467-6A) (1) in order to align the hook with the rear engine lift hook bracket.





22. Install the lift hook (J 28467-7A) through the rear engine lift hook bracket. Ensure the hook does not damage the surrounding components.





23. Hand tighten the lift hook wing nuts (J 28467-34) securely to remove all slack from the engine support fixture assembly.

Removal Procedure





1. Remove the J 28467-8.
2. Remove the J 42478.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the two rearward strut bolts to the right and left struts towers.
^ Tighten the strut tower bolts to 60 Nm (44 ft. lbs.).