Module Replacement - Front Power Window

REMOVAL PROCEDURE

CAUTION: Refer to Express Window Down Caution in Service Precautions.




1. Remove the door trim panel.
2. Remove the door control module.
3. Remove the water deflector.
4. Remove the speaker assembly.
5. Remove the window.
6. Disconnect the lock rod from the outside door handle.
7. Disconnect the outside handle rod.
8. Remove the 3 fasteners from the door latch assembly.
9. Remove the 2 upper fasteners (1) from the module.
10. Loosen the remaining fasteners (2).




11. Remove the module assembly.




12. Disconnect the inside door handle and lock rods from the door latch by releasing the retainers (1, 2).




13. Lift the door latch off the retainer (1).

INSTALLATION PROCEDURE




1. Install the door latch onto the retainer (1).




2. Install the inside door handle and lock rods to the door latch.
3. Fasten the inside door handle and lock rods to the latch by closing the clips (1, 2).




4. Install the outside door handle rod (2) on to the retainer (1) for ease of installation.
5. Connect the electrical connectors to the door latch.




6. Start the fasteners (2) in the module.




7. Install the module into the door.




8. Align the fasteners (2) installed in the module with the keyhole slots in the door.

NOTE: Refer to Fastener Notice in Service Precautions.

9. Install the remaining fasteners (1).

Tighten
Tighten the fasteners to 10 N.m (89 lb in).

10. Install the 3 fasteners to the latch assembly.

Tighten
Tighten the fasteners to 10 N.m (89 lb in).

11. Install the handle and lock rods to the outside door handle.
12. Install the window.
13. Install the speaker assembly.
14. Install the trim panel bracket.
15. Install the water deflector.
16. Install the door control module.
17. Install the door trim panel.