Linear Shift

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the shift lever from the linear shift assembly. Refer to Shift Lever Replacement - On Vehicle.
3. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement- On Vehicle.
4. Disconnect the automatic transmission shift lock actuator from the linear shift assembly.
5. Disconnect the transmission shift cable from the linear shift assembly.





6. Disconnect the park lock cable assembly (1).
7. Insert a small screwdriver into the slot on the lock module assembly and push against the park lock cable locking tab to remove the park lock cable.





8. Remove the linear shift assembly retaining screws.
9. Remove the linear shift assembly.

Installation Procedure





1. Install the linear shift assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the linear shift assembly retaining screws.
- Tighten the linear shift assembly retaining screws to 62 Nm (46 ft. lbs.).





3. Connect the park lock cable assembly (1) to the lock module assembly.





4. Install the automatic transmission shift lock actuator to the linear shift assembly.
5. Install the transmission shift cable to the linear shift assembly.
6. Adjust the automatic transmission shift lock. Refer to Automatic Transmission Shift Lock Actuator Replacement in Shift Lock Controls.
7. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement- On Vehicle.
8. Install the shift lever. Refer to Shift Lever Replacement- On Vehicle.
9. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.