Oil Level Sensor: Service and Repair
ENGINE OIL LEVEL SENSOR REPLACEMENTREMOVAL PROCEDURE
1. Raise and suitably support the vehicle.
2. Remove the engine oil drain plug in order to drain the engine oil.
3. Disconnect the oil level sensor electrical connector (1).
4. Remove the oil level sensor from the oil pan.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the oil level sensor from the oil pan.
Tighten
Tighten the engine oil level sensor-3.8L to 20 N.m (15 lb ft).
2. Connect the oil level sensor electrical connector (1).
3. Install the engine oil drain plug.
Tighten
Tighten the engine oil drain plug to 30 N.m (22 lb ft).
4. Lower the vehicle.
5. Refill the engine with new engine oil.