Inflatable Restraint Side Impact Sensor Replacement
INFLATABLE RESTRAINT SIDE IMPACT SENSOR REPLACEMENTREMOVAL PROCEDURE
1. Disable the SIR system.
2. Remove the center pillar lower trim.
3. Loosen the two inflatable restraint side impact sensor fasteners (2).
4. Remove the inflatable restraint side impact sensor (1) from the center pillar (3).
5. Remove the Connector Position Assurance (CPA) from the side impact sensor connector.
6. Disconnect the side impact sensor connector.
INSTALLATION PROCEDURE
1. Connect the side impact sensor connector to the side impact sensor (1).
2. Install the CPA to the side impact sensor connector.
3. Install the side impact sensor (1) to the center pillar (3).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the fasteners (2) to the side impact sensor (1).
Tighten
Use only hand tools to tighten the fasteners to 10 N.m (89 lb in).
5. Install the center pillar lower trim.
6. Enable the SIR system.