Power Window Switch Replacement - Rear Door

POWER WINDOW SWITCH REPLACEMENT - REAR DOOR

REMOVAL PROCEDURE

IMPORTANT:
^ When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.
^ Use a protective coating/tape at the point of insertion of the flat surface tool. Damage to the inner door panel may occur if it is not protected.




1. Insert a plastic flat-bladed tool at the front edge of the switch mounting plate. Press rearward in order to release the switch mounting plate retainer.
2. Lift the mounting plate and switch from the trim panel.




3. Disconnect the electrical connector from the power window switch.
4. Remove the switch from the mounting plate.

INSTALLATION PROCEDURE




1. Install the switch tabs into the mounting plate.
2. Press down on the tabs in order to secure the switch.




3. Connect the electrical connector to the window switch.
4. Align the mounting plate to the door trim panel opening and press down to secure.