Electric Park Lock Module - Assemble

- Tools Required
- J 41352 Modular Column Holding Fixture





1. Install the electric park lock (2) into the electronic lock module assembly (1).





Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the TORX(R) head screw (1) into the electric park lock (3).

- Tighten the TORX(R) head screw to 1.5 Nm (13 inch lbs.).

3. Install the black connector (2) into the electric park lock (3).





4. Install the upper trim cover (2) onto the steering column.
5. Screw the 2 TORX(R) head screws (1) into the upper trim cover (2).

- Tighten the 2 TORX(R) head screws to 1.5 Nm (13 inch lbs.).





6. Install the lower trim cover (2) onto the upper trim cover.
7. Match the tab slots on the lower trim cover (2) with the locking tabs on the upper trim cover.
8. Tilt the lower trim cover (2) up.
9. Slide the lower trim cover (2) forward until the locking tabs snap into the tab slots.
10. Screw the 2 pan head tapping screws (1) into the lower trim cover (2).

- Tighten the 2 pan head tapping screws to 3.5 Nm (31 inch lbs.).





11. Remove the steering column and J 41352 from the vise.
12. Install the tilt knob into the lower trim cover.