Electronic Column Lock Module - Disassemble

1. Remove the steering column tilt head housing. Refer to Steering Column Tilt Head Housing Disassemble - Off Vehicle (Column Shift) or Steering Column Tilt Head Housing - Disassemble - Off Vehicle (Floor Shift).
2. Remove the steering column lock cylinder set. Refer to Steering Column Lock Cylinder Set Disassemble - Off Vehicle (Column Shift) or Steering Column Lock Cylinder Set - Disassemble - Off Vehicle (Floor Shift).
3. Remove the connector (2) from the electric park lock (3).
4. Remove the TORX(R) head screw (1) from the electric park lock (3).





5. Remove the electric park lock (2) from the electronic lock module assembly (1).





6. Remove the key alarm connector (1) from the electronic lock module assembly (2).
6.1. Rotate the key alarm connector (1) 90 degrees.
6.2. Pull the key alarm connector (1) out of the electronic lock module assembly (2).





7. Remove the 2 tapping screws (2) from the ignition and key alarm switch assembly (1).
8. Let the ignition and key alarm switch assembly (1) hang freely.





Important: The lock bolt assembly (4) is under slight spring tension from the lock bolt spring (3). Hold the lock bolt (4) in place while removing the electronic lock module assembly (2).

9. Remove the 3 pan head tapping screws (1) from the electronic lock module assembly (2).
10. Remove the electronic lock module assembly (2) from the steering column tilt head assembly (5).
11. Remove the lock bolt assembly (4) from the steering column tilt head assembly (5).
12. Remove the lock bolt spring (3) from the lock bolt assembly (4).