Body Control Module (BCM) - Programming/RPO Configuration
INTRODUCTIONThe procedures below are designed to set-up the Body Control Module (BCM) correctly during BCM related service. Before you start, read these procedures carefully and completely.
IMPORTANT: The following procedures must be followed:
1. Read this procedure carefully and completely.
2. The BCM will not function properly if the Setup New BCM procedure is not performed.
3. Perform the Programming Theft Deterrent System Components in Antitheft and Alarm Systems after successfully finishing the Setup New BCM procedure. If the Programming Theft Deterrent System Components procedure is not performed after a BCM replacement, one of the following conditions will occur:
- The vehicle will not be protected against theft by the PASSLOCK system
- The engine will not crank nor start.
SETUP NEW BODY CONTROL MODULE (BCM)
IMPORTANT: After the procedure is completed, the personalization settings of the BCM are set to a default setting. Inform the customer that the personalization must be set again.
The following procedure will set up the new BCM:
1. Connect a Tech 2 to the Data Link Connector (DLC).
2. Turn the ignition switch ON.
3. Select "Diagnostics" and input all of the required data to select the correct vehicle when prompted by the Tech 2.
4. Select "Body" and then "Body Control Module".
5. Select "Special Functions".
6. Select "New VIN" and follow the screen directions to input all required data.
7. Exit back to the "Special Functions" menu.
8. Select "BCM Reprogramming".
9. The scan tool will display "Do you want to setup a Body Control Module?". At the prompt, select "Setup BCM" soft-key on the scan tool.
10. The scan tool will display "Now setting up the new Body Control Module".
11. When the BCM has been setup successfully, the scan tool will display "Body Control Module setup is complete".
12. When the BCM Setup Procedure and VIN have been entered, proceed with the procedure Programming Theft Deterrent System Components in Antitheft and Alarm Systems.