Radio/Stereo: Service and Repair

RADIO REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel cluster trim plate.
2. Remove the instrument panel accessory trim plate.
3. Remove the retaining screws from the radio.
4. Disconnect the electrical and the coaxial cable connectors from the radio.
5. Remove the radio from the instrument panel.

INSTALLATION PROCEDURE




1. Connect the electrical and the coaxial cable connectors to the radio.
2. Install the radio to the instrument panel.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the radio retaining screws.

Tighten
Tighten the radio retaining screws to 2 N.m (18 lb in).

4. Install the instrument panel cluster trim plate.
5. Install the instrument panel accessory trim plate.