Sunroof / Moonroof: Adjustments

Sunroof Window Height and Opening Fit Adjustment

Adjustment of the Sunroof Glass Panel Seal

The sunroof glass panel seal controls the entry of water to the drain channels. If the sunroof glass panel is correctly adjusted, the fit between the weatherstrip and the roof will be snug.


Complete the following steps in order to test the fit:

1. Insert a piece of paper between the roof and the weatherstrip.
2. Close the glass panel.
3. Pull out the paper.
If there is some resistance when you pull out the paper, the fit is correct. Proper adjustment is necessary to ensure that the amount of water to the sunroof drain hoses is not excessive. An improper fit may cause water leaks or objectionable wind noise.
4. Complete all of the glass panel to roof adjustments by changing the vertical height and centering of the glass panel.



Sunroof Glass Panel Height Adjustment





1. Slide the sunroof sunshade to the open position.
2. Position the sunroof glass panel to the fully closed position.
3. Loosen the four sunroof glass panel adjusting screws 2 screws on each side. The screws must remain tight enough to have the sunroof glass panel retain its adjusted position.




4. Individually adjust the 4 corners of the glass panel.
5. Adjust the front of the sunroof glass panel. Ensure that the sunroof glass front (3) is 0.787 mm (0.031 in) below the top surface of the roof panel. Also, the glass seal (1) is centered.
6. Adjust the rear of the sunroof glass panel. Ensure that the rear of the sunroof glass (2) is 0.787 mm (0.031 in) above the top surface of the roof panel.
7. Verify the adjustment of the sunroof glass panel seal.





Notice: Refer to Fastener Notice in Cautions and Notices.

8. Tighten the sunroof glass panel screws.

Tighten the screws to 4 N.m (35 lb in).