Seat Horizontal and Vertical Drive Cable Replacement

Seat Horizontal and Vertical Drive Cable Replacement

Removal Procedure

1. Remove the power seat adjuster. Refer to Front Seat Adjuster Replacement (Up to VIN 2G4W5525711252272) (Front Seat Adjuster Replacement (Up to VIN 2G4W5525711252272))Front Seat Adjuster Replacement (After VIN 2G4W5525711252272) (Front Seat Adjuster Replacement (After VIN 2G4W5525711252272)) .





Important: Initial removal of the nut securing the motor support bracket is suggested to gain access to the cable connector at motor for the inboard passenger side or the outboard driver side rear vertical gearnut.


2. Remove the cables by squeezing the oblong connector at the motors and the vertical/horizontal actuators.
3. Carefully flex the cable and remove it from the motor and horizontal/vertical actuator.



Installation Procedure





1. Carefully flex the cables and install them to the motors and horizontal/vertical actuators.
2. Firmly push the oblong connector at the end of the horizontal and vertical drive cables into the motors.
3. Install the power seat adjuster. Refer to Front Seat Adjuster Replacement (Up to VIN 2G4W5525711252272) (Front Seat Adjuster Replacement (Up to VIN 2G4W5525711252272))Front Seat Adjuster Replacement (After VIN 2G4W5525711252272) (Front Seat Adjuster Replacement (After VIN 2G4W5525711252272)) .