Electronic Brake Control Module: Service and Repair

Electronic Brake Control Module (EBCM) Replacement

Removal Procedure

Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.





1. Turn the ignition switch to the OFF position.
2. Remove red locking tab from connector lock tab (1).
3. Push down lock tab (1) and then move sliding connector cover (2) to the open position.
4. Disconnect the EBCM harness connector.
5. Remove any dirt/debris that has accumulated on the assembly.





6. Remove the four EBCM to BPMV retainers.

Important: Do not pry apart using a tool. Be careful not to damage BPMV surface.

Important: Care must be taken not to damage the solenoid valves when the EBCM is removed from the BPMV.

7. Separate the EBCM from the BPMV by gently pulling apart until separated.

Installation Procedure





1. Clean the BPMV surface with alcohol using a clean rag.
2. Install the EBCM to the BPMV.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the four retainers that attach the EBCM to BPMV.
^ Tighten the retainers to 5 Nm (44 inch lbs.).





4. Connect the EBCM harness connector.
5. Push down lock tab (1) and then move sliding connector cover (2) back in the home position to lock.
6. Insert red locking tab back in place.
7. Turn the ignition switch to the RUN position, do not start engine.
8. Perform the Diagnostic System Check - ABS