B2587

CIRCUIT DESCRIPTION
The Body Control Module (BCM) controls the park lamp relay. The BCM grounds the park lamp relay control circuit energizing the park lamp relay.

CONDITIONS FOR RUNNING THE DTC
The BCM must not be commanding the Park Lamp relay to energize.

CONDITIONS FOR SETTING THE DTC
^ The BCM detects a short to ground or open in the park lamp relay control circuit when it is not trying to energize the Park Lamp relay.
^ The condition above must be present for more than 0.3 seconds.

ACTION TAKEN WHEN THE DTC SETS
The BCM stores DTC B2587 in memory.

CONDITIONS FOR CLEARING THE DTC
^ A current DTC B2587 will clear if the short to ground or open in the park lamp relay control circuit is no longer detected by the BCM.
^ A history DTC B2587 will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present.
^ The BCM receives a clear code command from the scan tool.

DIAGNOSTIC AIDS
^ If the DTC B2587 is a history DTC, the fault may be intermittent. Refer to Testing for Intermittent and Poor Connections in Diagnostic Aids.
^ The following conditions may cause an intermittent malfunction to occur:
- An intermittent short to ground or open in the park lamp relay control circuit.
- The park lamp relay coil is intermittently shorted to ground or open.
- The BCM is intermittently shorted to ground or open.

TEST DESCRIPTION

Steps 1-4:

Steps 5-15:

The numbers below refer to the step numbers on the diagnostic table.
2. Listen for an audible click when the park lamp relay operates. Command both the ON and OFF states. Repeat the commands as necessary.
4. Tests for voltage at the coil side feed of the park lamp relay. The LP Park fuse supplies power to the coil side feed of the park lamp relay.
5. Verifies that the BCM is providing ground to the park lamp relay.
6. Tests if ground is constantly being applied to the park lamp relay.