B3102
CIRCUIT DESCRIPTIONThe remote control door lock receiver (RCDLR) communicates with the body control module (BCM) through the keyless entry serial data circuit. When any button on the keyless entry transmitter is pressed, the transmitter sends a signal to the RCDLR. The RCDLR sends a lock, unlock, rear release, or panic alarm request to the BCM, depending on which button is pressed on the transmitter. The BCM receives the message and performs the appropriate function. The BCM also uses the keyless entry serial data circuit in order to communicate with the RCDLR when programming transmitters.
CONDITIONS FOR RUNNING THE DTC
^ The ignition is ON.
^ The system voltage is at least 9.0 volts and no more than 16.0 volts.
CONDITIONS FOR SETTING THE DTC
^ The keyless entry serial data circuit is shorted to ground.
^ The above conditions must be met for approximately 300 milliseconds.
ACTION TAKEN WHEN THE DTC SETS
The keyless entry system will not operate.
CONDITIONS FOR CLEARING THE DTC
^ A current DTC will clear when the fault is no longer present and the ignition switch is cycled.
^ A history DTC will clear after 100 consecutive ignition cycles without a fault present.
^ A scan tool may be used to clear history and current DTC(s).
TEST DESCRIPTION
Steps 1-9:
The number below refers to the step number on the diagnostic table.
3. This step checks the keyless entry serial data circuit for voltage supplied by the body control module (BCM).