Oil Pump: Service and Repair

Oil Pump Replacement

Removal Procedure
1. Remove the oil pan.





2. Remove the oil pump bolt from the rear crankshaft bearing cap.
3. Remove the oil pump and the driveshaft.
4. Inspect the driveshaft at both ends for rounding of the corners.
5. Inspect the oil pump.

Installation Procedure

Important: Rotate the driveshaft as necessary in order to obtain the engagement with the oil pump drive unit.





1. Install the driveshaft and the oil pump.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the oil pump bolt to the rear crankshaft bearing cap.
Tighten the bolt to 41 Nm (30 ft. lbs.).
3. Install the oil pan.