57. Intake Manifold Clean and Inspect - Lower

Intake Manifold Cleaning and Inspection - Lower

- Tools Required
- J 21882 Oil Suction Pipe Installer





1. Remove the engine coolant temperature sensor.





2. Remove the intake manifold coolant pipe bolt.
3. Remove the intake manifold coolant pipe.





4. Clean the intake manifold gasket mating surfaces.
5. Clean the fuel injector bores.
6. Inspect the threaded holes for damage.
7. Inspect the intake manifold mating surfaces for damage.
8. Repair or replace the intake manifold as necessary.





9. Apply sealant GM P/N United States 12345493, GM P/N Canada 10953488 or equivalent to the end of a new intake manifold coolant pipe.
10. Install the intake manifold coolant pipe using the J 21882.

Notice: Refer to Fastener Notice in Service Precautions.

11. Install the intake manifold coolant pipe bolt.
Tighten the intake manifold coolant pipe bolt to 10 Nm (89 inch lbs.).





12. Install the engine coolant temperature sensor. Apply sealer GM P/N United States 12346004, GM P/N Canada 10953480 or equivalent to the coolant temperature sensor.
Tighten the engine coolant temperature sensor to 23 Nm (17 ft. lbs.).