Operation CHARM: Car repair manuals for everyone.

82. Valve Rocker Arm Cover Installation - Right

Valve Rocker Arm Cover Installation - Right





1. Install the valve rocker arm cover gasket into the valve rocker arm cover.
2. Apply sealer GM P/N 12345739 or the equivalent to the notches where the cylinder head and intake manifold meet.
3. Install the valve rocker arm cover.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the valve rocker arm cover bolts.
- Tighten the valve rocker arm cover bolts to 10 Nm (89 inch lbs.).





5. Install the vacuum lines from the upper intake manifold.





6. Install the ignition coil studs.
- Tighten the ignition coil studs to 25 Nm (18 ft. lbs.).
7. Install the electronic ignition control module.
8. Install the electronic ignition control module nuts and bolts.
- Tighten the electronic ignition control module nuts and bolts to 25 Nm (18 ft. lbs.).
9. Install the spark plug wires.