Turn Signal Flasher: Service and Repair
HAZARD AND TURN SIGNAL FLASHER REPLACEMENTREMOVAL PROCEDURE
1. Remove the left instrument panel (I/P) insulator.
2. Remove the steering column filler panel.
3. Remove the I/P driver knee bolster bracket.
4. Grasp the hazard and turn signal flasher and slide the flasher to the right to release the flasher tabs from the slots on the BCM bracket.
5. Disconnect the electrical connector from the flasher.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the hazard and turn signal flasher.
2. Position the flasher to the BCM bracket, then slide the flasher to the left to secure the flasher tabs into the retaining slots on the bracket.
3. Install the I/P driver knee bolster bracket.
4. Install the steering column filler panel.
5. Install the left I/P insulator.