Accelerator Controls Cable Replacement

REMOVAL PROCEDURE




1. Remove the left instrument panel sound insulator.
2. Remove the accelerator cable (5) from the accelerator pedal (1).
3. Squeeze the accelerator cable cover tangs and push the accelerator cable through the bulkhead.




4. Remove the cruise control cable from the throttle body lever.
5. Remove cruise control cable from the bracket.




6. Remove the accelerator cable from the retaining clip.




7. Remove the accelerator cable from the throttle body lever.
8. Remove the accelerator cable from the accelerator cable bracket.




9. Remove the accelerator cable from vehicle noting cable routing.

INSTALLATION PROCEDURE

NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.




1. Install accelerator cable using the routing noted during removal.




2. Install the snap retainer through the bulkhead.
3. Connect the accelerator cable (5) in the slot in the accelerator pedal lever (1).
4. Seat the snap retainer in the accelerator pedal lever.




5. Install the accelerator cable to the throttle body lever.
6. Install the accelerator cable to the accelerator cable bracket.




7. Install the cruise control cable to the throttle body lever.
8. Install the cruise control cable to the bracket.




9. Install the accelerator cable to the retaining clip.
10. Inspect for complete throttle opening and closing positions by operating the accelerator pedal. Also inspect for poor carpet fit under the accelerator pedal.
11. Install the left instrument panel sound insulator.