Crankshaft Position (CKP) Sensor Replacement (24X)

REMOVAL PROCEDURE




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
2. Remove the lower air deflector.
3. Disconnect the sensor electrical connector.
4. Remove the sensor from the bracket.
5. Remove the crankshaft balancer.
6. Note the routing of the sensor harness before removal.
7. Remove the harness retaining bolt (4) and the clip (3).
8. Remove the CKP sensor bolts (4).
9. Remove the CKP sensor (1).

INSTALLATION PROCEDURE




1. Install the 24X crankshaft position sensor (1) to the front cover.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the CKP sensor bolts (4).

Tighten
Tighten the bolts to 10 N.m (89 lb in).

3. Install the harness retaining clip (3) with bolt (4).

Tighten
Tighten the bolt (4) to 10 N.m (89 lb in).

4. Connect the CKP sensor electrical connector.
5. Install the CKP sensor harness to the bracket.
6. Install the crankshaft balancer.
7. Install the lower air deflector.
8. Lower the vehicle.
9. Perform the crankshaft position (CKP) system variation learn procedure. Programming and Relearning